So I want to set up a bank of gun turrets, using a Power Switch to regulate the flow of power to/from the turrets. I am guessing that I need to set up a single run of lines from the main grid>to the power switch>to the gun turrets. But I am having issues and it doesn't seem to work. I can't get the turrets to come on with the switch on or off.
Basically here is my setup:
1: Grid one throughout my base
2. Grid two that runs in two directions to reach the guns (g)
g: gun turret bank
S: Power Switch
2gggg2
2 2
1 S2222
1 1
111111
Any suggestions?
Soooo what i do is....I go inside a room or whatever is close to the "edge" of my base I run power lines to the corner, but I do not run one on the actual corner, then i do a power switch in that area and continue the line on the other wall Hope this picture makes sense
s = switch
w = power line inside a wall
x = wall
- = power line no wall
t = turrets
x
x t
x
sw--------- t
wwwwwwx
t