Messages

Thanks very much for your help. I was able to get the two mods to play nice together.

You are correct, I missed installing the CCL.

Thanks for the help, I very much appreciate it.

I'm having a issue with the mod.

I've installed it in the mods folder, and all three of the NPDs are present in game. I go to build the skinny front NPD. My survivor will bring all the materials and put in the effort, but the NPD will disappear completely after completion. The resources and the NPD are just gone.

Am I installing the mod incorrectly, as all three of the various NPDs are present in the Production tab, which I recall from previous versions (pre-A13) would cause problems and as such only one of the various new NPDs could be installed at a time. I don't see an option for selecting only one of the NPDs, however.

I routinely play Rimworld, with a large number of mods.

Since the move to A13, and the updating that has happened to mods, there seems to be an incompatibility issue between VeinMiner and HaulPriority Lite, whereby in the Orders tab, the last three controls are from which of the aforementioned mods is loaded last by the game.

Is there a way to expand the "empty" controls, so I can have the controls for both VeinMiner and HaulPriority?

After double-checking, Vent, Active Vent, Small Cooler, and Medium Heater are not able to be placed. Everything else as far as heating and ducting are able to be placed.

which version you on? - if you cant place vents etc - check that you have updated rimworld and CCL

Updating to the most current version of Rimworld and including the CCL has resolved the issue. I can now install vents and active vents. Thanks for the help all.

I'm running Rimworld version 12.906 and RedistHeat Version 41 (according to the Mod menu, it's Redist V40d).

I havne't ever updated the CCL, and having spent some time tonight reading the error log when loading the game, I think that might be source of the problem.

After double-checking, Vent, Active Vent, Small Cooler, and Medium Heater are not able to be placed. Everything else as far as heating and ducting are able to be placed.

Yes I do. I'm adding an attachment. The walls I'm currently looking to add vents/ smart vents to are the walls between the colonists/prisoners sleeping areas, so they're all sharing heat.

[attachment deleted due to age]

I'm having an issue whereby I am completely unable to build vents or active vents at all. This was an issue that was present with the previous version and is continuing with the current version.

I'm running no other mods that would impact vents in anyway. I can select them, but I cannot place them in walls anywhere in my colony structure. They are the only two aspects of climate control that are affected.

First, I love this mod. It brings a nice element to the game, and is very practical.

That being said, I'm shite at working with it. I can't figure out how to regulate heat across the network to get the rooms heated to where their occupants want, or where they need to be.

The bedrooms of the colonists when hooked to this system have never reached higher than 10C, and routinely fall to near 0C.

I've attached a picture, that is my entire base at present. In the lower left, I have my industrial heater and industrial cooler. The heater is in a room that is attached to my upper ducts. It has five intakes, and is piped to Smart Duct Outlets. The rooms are all currently set to the upper ducts as it is cold outside the base (night time temperatures for this location in October reach -8C).

I have a wall between my cooler/heater. All Smart Duct Outlets are set for 20C.
Coolers Target Temp: -20C
Heaters Target Temp: 20C
Net Temperature (Upper)/Heat: 19C
Net Temperature (Lower)/Cold: 17C

What am I do wrong? I've read this entire thread, and tried to figure out what is wrong.

[attachment deleted due to age]